news

NEW PROTECTOR CASES IN STOCK!

Fun WatchBands

The improved SnuG protector cases are now in stock and ready to ship! They offer a much more secure hold than the previous version. 

It is very important to take care to make sure the case is properly installed. Also note a screen protector may not be compatible with our cases.

PROTECTOR CASE INSTALL:
Our cases are made from soft and stretchable silicone rubber that works almost as a skin.
You must use the same care you would use when putting on a screen cover to make sure everything is lined up and any air is pressed out.
TAKE THE WATCH OFF TO INSTALL

  • After you line up the hole with the power button and stretch the band around it is important to run your finger around the watch face/top ridge of the protector while firmly pressing down. 
  • You may then need to slightly pull the bottom protector lip to evenly stretch it under the ridge of the watch.
  • Pinch the protector on all sides to seal it in place and get any air out.
  • Carefully reinspect the power button hole again. If the case is even a little bit covering the power button, or its outside ring, it is not sealed around and is likely to come off.

 

We look forward to your feedback on the new cases!


Older Post Newer Post


Leave a Comment

Please note, comments must be approved before they are published